Beginning Embedded Electronics - 11

Common Mistakes, Tips and Tricks

1. All grounds need to be connected together.
2. TX/RX loop back trick: When in doubt of a serial conversion circuit, short the TX and RX pins together to get an echo.
3. Normal length wires for breadboard connections: Don't use a 9" wire where a 2" wire will do.
4. Minimize short potential in your breadboard wiring: Don't expose an inch of wire from the insulation if all you need is 1/4".
5. You will learn best when you have a *simple* project to work on. Don't create the 'house-pet robot' just yet.
6. Google is, of course, your friend. When you don't know, go do some research.
7. for(x = 0 ; x <>
8. Soldering basics: Wet your @#$% sponge.
9. Take your time with ground plane solder joints. Do not be fooled by a cold joint.
10. Never trick yourself into thinking you're that good. Print out a 1:1 and compare the footprints!
11. Check that TX and RX are wired correctly to all peripherals. TX/RX swap is the one of the greatest causes of PCB failures.
12. When laying out a PCB with SMD micros, don't forget to include the programming port!
13. Don't run silkscreen across pads.
14. Connector PCB footprint mis-numbering: always check the pin number on your connector - they can have very obfuscated schemes.
15. In Eagle, use vector fonts only!
16. Review your gerber files before submitting them.